User Tools

Site Tools


soft:cadence:monte_carlo:start

This is an old revision of the document!


Monte Carlo analysis

AMS 3.70

HIT-KIT 3.70; spectra


details: file:///opt/cds/designKits/ams_v3.70/www/hitkit/circuit_sim/montecarlo/mismatch.html

Models setting

To run MC simulations you must set Monte Carlo sections of elements models.
So run virtuoso analog design environment and click setup → model libraries. Next change in libraries (cmos53, res, cap, etc) name of section, from *tm to *mc. For example cmostm → cmosmc.

Run of simulation

After change the models, you run the simulation: tools → monte carlo
Gauss distibution requiere over 30 samples. So number of runs should be higher than 30. To see all results, change save data between runs checkbox on true.

Results

Results as characteristic family:
In setup outputs set data type on wave.

Results as histograms:
In setup outputs set data type on scalar.

AMS 4.00

HIT-KIT 4.00; spectra


Models setting

To run MC simulations you must set Monte Carlo sections of elements models.
ICFB → Hit-Kit Utilities → Simulation Utilities → Change Model Files → Set MC models

Run of simulation

Monte Carlo simulations are available in ADE XL. If cellview adexl doesn't exist: in schematic window click Launch → ADE XL In dialog box choose Create new view and click OK (if adexl cellview exists - simple open it).
In toolbar Run change single run… on Monte Carlo Sampling. In Simulation options (first button on right) set method (mismatch, process or all), specified number of iterations and finally mark Save Data to Allow Family Plots. Finally run the simulations (green button on run toolbar).



Remark All simulations type (dc, ac, etc) and outputs are set on Data View in Tests branch.

/services/www/http/wiki/data/attic/soft/cadence/monte_carlo/start.1273654972.txt.gz · Last modified: 2019/03/08 14:06 (external edit)